[ben22]

I am facing an issue with my NEMA 17 stepper motors that have a step angle of 0.9° per step. I am using DRV8825 drivers with a microstepping setting of 1/16. During the homing process of all axes, the X-axis gets stuck, and the motor loses steps as it tends to move too quickly. However, when I perform homing for the X-axis only, this problem does not occur. I have checked the current settings and ensured that there are no mechanical obstructions. Can anyone help me identify the possible causes of this issue and suggest potential solutions?

[Rares]

hi Ben,
Please check you current adjustment via that small potentiometer on the drv board.
it could be that the current value is set too low.